- One holder for the size 1 sensor and one holder for the size 2

- Can be autoclaved

· Sensor stays in the holder for all of the exposures!

No time wasted with assembling different configurations for different areas of the mouth - the sensor simply rotates to any position desired!

· Thinnest bite block available! Extraordinary Bite Wings and FMX!

· Fully assembled and ready to use in a single unit. No multitude of parts to replace and keep track of.

· Less than half the cost of old style bulky metal and plastic positioning systems.

Pricing excludes VAT and are recommended selling prices

The AnyRay size 1:2 fits the following sensors:
- Schick wireless size 1

The AnyRay size 1:3 fits the following sensors: 26.0mm
- WDS with Bluetooth technology size 1
- Anthos DSX size 1

The AnyRay 1:3  is the best fit for Trophy / Kodak child sensor, it is an acceptable fit, but not a perfect fit.

The AnyRay size 1:4 fits the following sensors: 25.0mm
- Schick wired size 1
- PlanMeca Dixi/2/3 size 1
- Sirona Sidexis universal sensor
- Instrumentarium Sigma size 1
- Dent-X EVA size 1
- E2V size 1
- Gendex Visualix size 1
- Mediadent size 1
- ImageRay size 1
- Visiodent size 1
- Sometch size 1
- Vistaray size 1
- Cygnus size 1

The AnyRay size 2:1 fits the following sensors: 30.5mm
- Schick wired size 2
- Schick wireless size 2
- PlanMeca Dixi/2/3 size 2
- Sirona Sidexis fullsize sensor
- Fimet F1 iOX size 2
- Instrumentarium Sigma size 2
- Dent-X EVA size 2
- Anthos DSX size 2
- WDS with Bluetooth technology size 2

The AnyRay 2:1 is the best fit for Trophy / Kodak Adult sensor, it is an acceptable fit, but not a perfect fit.

The AnyRay size 2:5 fits the following sensors: 32.5mm
- E2V size 2
- Gendex Visualix size 2
- Mediadent MDX size 2
- ImageRAYi size 2
- Visiodent size 2
- Sometech size 2
- Vistaray size 2
- Cygnus size 2
 

Cleaning

Before cleaning, the rotating parts of the holder must be restored into one of its distinct positions.
 

There are three ways of cleaning the holder:

- Wipe with sterile solution
- Dishwasher/desinfector
- Autoclave
 

NOTE! If the moving parts of the holder is not in one of its distinct positions when cleaned, the plastics will deform and the distinct position till be destroyed. To restore them place the moving parts in its positions, autoclave the holder, leave the holder to cool. The plastics will then reform and regain its distinct positions. Always use a sensor barrier before attaching the sensor to the holder. Centre the holder on the sensor and snap the sensor into position. Do not drag the sensor into position

 www.theanyray.com

Copyright © 2010 Dentoid Limited  

Information contained on this site is subject to change without notice 
Site last updated 25/04/2010